Contact Form 2200 SERIES CONVEYORS: Cleated Belt End Drive
Specifications:
- Sealed ball bearings
- Loads up to 80 lbs.* (36 Kg)
- Belt speeds up to 264 ft/min. (81 M/min)
- Belt widths: 1.75” (44) to 24” (610)
- Conveyor lengths: 18” (456) to18’ (5,486)
- Cleats available from .24” (6) to 2.36” (60) high
- 1.25” (32) diameter drive and idler pulleys turn
approximately 4.2” (107) of belt per revolution - 12mm diameter integral drive shaft
- V-grooved 14 gauge stainless steel bedplate
- Metric fasteners
-
models available
Features/Benefits:
- Quick 5 minute belt change
- Rack pinion belt tensioning for fast, accurate single point belt tensioning
- Aluminum die cast head plates eliminate painted surfaces
- V-groove bedplate with guided belt provides positive belt tracking, even under demanding side load applications
- Non V-guided belts use our patented belt tracking cams, offering you the widest belt selection possible
- Strong, box-like construction resists damaging frame twist
- 50% more belt take-up extends conveyor belt life
- Stand mounting brackets are easily re-positioned along the T-slot
- Special length conveyors to .12” (4) increments at standard price and delivery
- Motion Sensor Ready
Note: Standard idler pulley houses a small magnet which may be omitted upon request for magnetically sensitive products and applications.
Change Belts in Less than 5 Minutes! |
||
 |
 |
 |
Loosen fasteners and |
Remove old belt and replace. |
Adjust tension on new belt, |
| STANDARD SIZES | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Conveyor Width Reference | 02 | 03 | 04 | 05 | 06 | 08 | 10 | 12 | 18 | 21 | 24 |
| Conveyor Belt Width (W) | 1.75” (44) |
2.75” (70) |
3.75” (95) |
5” (127) |
6” (152) |
8” (203) |
10” (254) |
12” (305) |
18” (457) |
21” (533) |
24” (610) |
| Conveyor Length Reference | 0200 | 0001 increments up to... | 1800 | ||||||||
| Conveyor Length (L) | 2’ (610) | .12” (3) increments up to... | 18’ (5,486) | ||||||||
Note: Lengths 13’ to 18’ available in widths 6” to 24” only.
Notes:
-
Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors. See Performance Charts / Data for details.
-
Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
-
Dimensions are represented in inches, feet, and (millimeters).
-
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
-
Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.