Contact
Form 3200 SERIES CONVEYORS: Cleated Belt End Drive
Specifications:
- Load up to 400 lbs.* (181 Kg)
- Belt Speeds up to 275 ft/min. (128 M/min)
- Belt widths: 3.75” (95) to 24” (610)
- Conveyor lengths: 3’ (914) to 40’ (12,192)
- Cleats available from .24” (6) to 2.36” (60) high
- 2” (51) minimum cleat spacing
- 1.62” (41) of belt take-up on conveyors up to 20’ long
- 3.24” (82) of belt take-up on conveyors over 20’ long
- 3” (76) diameter drive pulley turns approximately 9.7” (246) of belt per revolution
- Metric fasteners
-
models available
Features/Benefits:
- Quick 5 minute belt change
- Rack and pinion belt tensioning for fast, accurate single point belt tensioning
- Steel nitrite coated head plates eliminate painted surfaces
- V-groove bed plate with guided belt provides positive belt tracking, even under demanding side load applications
- V-guided belts eliminate belt tracking
- Strong, box-like construction resists damaging frame twist
- Stand mounting brackets and return belt rollers are easily re-positioned along the frame
- Special length conveyors to .12” (3) increments at standard price and delivery
- Special width conveyors to 2” (51) increments at standard price and delivery
Sidewall Cleated Belts
are used for small part handling.
Available in 6" & Wider Belt Widths
Rack and Pinion
belt tensioning design
allows the tail section to be easily
slid back for quick belt removal.
Change Belts in Less than 5 Minutes! |
||
 |
 |
 |
Loosen fasteners and |
Remove old belt and replace. |
Adjust tension on new belt, |
| STANDARD SIZES | ||||
|---|---|---|---|---|
| Conveyor Width Reference | 04 | 06 | 02 increments up to... | 24 |
| Conveyor Belt Width (W) | 3.75” (95) |
6” (152) |
2” (51) increments up to... | 24” (610) |
| Conveyor Length Reference | 0300 | 0001 increments up to... | 1800 | |
| Conveyor Length (L) | 3’ (914) | .12” (3) increments up to... | 40’ (12,192) | |
Notes:
-
Conveyors wider than 40” (1,016) require V-Guide belt tracking.
-
Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors.
-
Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
-
Dimensions are represented in inches, feet, and (millimeters).
-
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
-
Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.