Contact Form 6200 SERIES CONVEYORS: Cleated Belt End Drive
Specifications:
- 11 gauge stainless steel roll formed frame
- Sealed bearings
- Belt widths: 1.75” (44) to 12” (305 MM)
- Conveyor lengths: 2’ (610) to 12’ (3,658 MM)
- 1.5” (38) bottom of frame to top of belt
- 12mm diameter integral drive shaft
- The 1” (25) diameter drive pulley turns approximately
3.4” (86) of belt per revolution - Load capacity up to 80 Lbs* (36 Kg)
- Belt speeds up to 150 ft/min (46 M/min)
- Cleats available from .24” (6) to 2.36” (60) high
- Metric fasteners
- Mild steel head and tail plates with black nitrite finish
- Motion sensor switch ready
models available
Features/Benefits:
- Wedge-Lok system for impact protection
- Streamlined design fits where other conveyors do not
- Quick 5 minute belt change for increased uptime
- Low maintenance sealed bearings in both head and tail spindles
- Lengths in .12” (4) increments
- Quick clamp rail for easy mounting of bolt-on accessories
- Rack and pinion design offers fast single point belt tensioning
- V-Groove frame with guided belt ensures accurate tracking
- A variety of cleat heights to meet application needs
Wedge-Lok™
System
Change Belts in Less than 5 Minutes! |
||
 |
 |
 |
Loosen fasteners and |
Remove old belt and replace. |
Adjust tension on new belt, |
| STANDARD SIZES | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| Conveyor Width Reference | 02 | 03 | 04 | 05 | 06 | 08 | 10 | 12 | |
| Conveyor Belt Width (W) | 1.75” (44) |
2.75” (70) |
3.75” (95) |
5” (127) |
6” (152) |
8” (203) |
10” (254) |
12” (305 MM) |
|
| Conveyor Length Reference | 0200 | 0001 increments up to... | 1200 | ||||||
| Conveyor Length (L) | 2’ (610) | .12” (3) increments up to... | 12’ (3,658MM) | ||||||
Note: Lengths 13’ to 18’ available in widths 6” to 18” only.
Cleat types and spacing limited on conveyors longer than 12’ due to belt weight
Cleat types and spacing limited on conveyors longer than 12’ due to belt weight
Notes:
-
Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors. See Performance Charts / Data for details.
-
Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
-
Dimensions are represented in inches, feet, and (millimeters).
-
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
-
Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.