Contact Form 6200 SERIES CONVEYORS: Flat Belt Center Drive
Specifications:
- 11 gauge stainless steel roll formed frame
- Sealed Bearings
- Belt widths: 1.75” (44) to 12” (305 MM)
- Conveyor lengths: 2’ (610) to 12’ (3,658 MM)
- 1” (25) diameter head and tail pulleys
- The 1.25” (32) diameter drive pulley turns
approximately 4.2” (107) of belt per revolution - 1.5” (38) bottom of frame to top of belt
- 12mm diameter integral drive shaft
- Loads capacity up to 120 Lbs* (54 Kg)
- Reversing center drive belt direction reduces load capacity by 66%
- Belt speeds up to 264 ft/min. (81 M/min.)
- Metric fasteners
- Mild steel head and tail plates with black nitrite finish
- Motion sensor switch ready
-
models available
Features/Benefits:
- Center Drive models free up conveyor ends for machine or operator interface
- The Center Drive module can be easily repositioned along the length of the conveyor
- Streamlined design fits where other conveyors do not
- Low maintenance sealed bearings in both head and tail pulleys
- Lengths in .12” (4) increments
- Belt materials to match application requirements
- Quick clamp rail for easy mounting of bolt-on accessories
- V-Groove frame with guided belt ensures accurate tracking
- Durable .25” (6) thick bottom wiper
Wedge-Lok™
System
 |
 |
Center Drive Module |
Gas Spring Belt Tensioner |
| STANDARD SIZES | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| Conveyor Width Reference | 02 | 03 | 04 | 05 | 06 | 08 | 10 | 12 | |
| Conveyor Belt Width (W) | 1.75” (44) |
2.75” (70) |
3.75” (95) |
5” (127) |
6” (152) |
8” (203) |
10” (254) |
12” (305 MM) |
|
| Conveyor Length Reference | 0200 | 0001 increments up to... | 1200 | ||||||
| Conveyor Length (L) | 2’ (610) | .12” (3) increments up to... | 12’ (3,658 MM) | ||||||
Note: Lengths 13’ to 18’ available in widths 6” to 18” only.
Notes:
-
Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors. See Performance Charts / Data for details.
-
Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
-
Dimensions are represented in inches, feet, and (millimeters).
-
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
-
Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.