Contact Form LPZ SERIES CONVEYORS: Flat Belt Center Drive
Specifications:
- Belt widths: 3.75” (95) to 48” (1,219)
- Conveyor lengths: 6’ (1,829) to 99’ (30,175)
- Loads up to 1000 lbs.* (455 kg)
- Adjustable angle, 0?q - 35?q
- Belt speeds to 368 ft/min (112 M/min)
- Belt direction is not reversible
- Drive module requires a 4’ (1,219) minimum section
- 6” (152) diameter drive pulley turns approximately,
18.8” (479) of belt per revolution - Metric fasteners
- Order Gearmotor seperately
Note: Conveyor wider than 40” ( 1,016) require V-guide belt tracking
Features/Benefits:
- Nose-over and walk-thru configurations
- Low maintenance sealed bearings
- Center Drives free up ends for machine and operator interface
- Center drive module can be easily repositioned along section length
- High strength anodized aluminum frame with clear coat finish
- T-Slots for easy mounting of pre-engineered accessories
- Belt types and materials to match application requirements
- Adjustable angle frames conform to applications
- Adjustment cams provide precise belt tracking for non V-guided belts
- Pneumatic belt tensioner maintains uniform belt tension
- Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors
Optional Interface Tail Section
- Sealed bearing
- 1” (25) diameter rollers
- Widths up to 48” (1219)
- Available at non-driven end
to assist in small part transfers
| STANDARD SIZES | ||||
|---|---|---|---|---|
| Conveyor Width Reference | 04 | 06 | 02 increments up to... | 48 |
| Conveyor Belt Width (W) | 3.75” (95) |
6” (152) |
2” (51) increments up to... | 48” (1,219) |
| Conveyor Length Reference | 0200 | 0001 increments up to... | 9700 | |
| Conveyor Length (L) | 2’ (610) | .12” (3) increments up to... | 97’ (29,566) | |
| L1 + L2 + L3 = Maximum 99’ (30,175) long conveyor. *Center drive module requires a 4’ (1,219) minimum section |
||||
Part Reference Guide (2.90 MB PDF)
Notes:
-
Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors. See Performance Charts / Data for details.
-
Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
-
Dimensions are represented in inches, feet, and (millimeters).
-
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
-
Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.