Contact Form LPZ SERIES CONVEYORS: Standard Cleated Belt End Drive
Specifications:
- Belt widths: 8” (203) to 24” (610)
- Conveyor lengths: 4’ (1,219) to 25’ (7,620)
- 1.62” (41) of belt take-up
- Load Capacity* up to 100 lbs.* (45 kg)
- Adjustable angle, 25?q - 60?q
- Belt speeds to 275 ft/min (83.8 M/min)
- Belt direction is not reversible
- Cleats available from .24” (6) to 2.36” (60) high
- 3” (76) dia. drive pulley turns approximately 9.7” (246) of belt per revolution.
- Metric fasteners
Features/Benefits:
- Z-Frame, nose-over and horizontal-to-incline configurations
- Rack and pinion offers single point belt tensioning
- Low Maintenance sealed bearings
- High strength anodized aluminum frame with clear coat finish
- T-Slots for easy mounting of pre-engineered accessories
- V-guided belts eliminate tracking adjustments
- Adjustable angle frames conform to applications
- Quick belt change increases uptime
Conveyor load capacity depends on conveyor size, incline, motor position,
accumulated
loads and other factors. See Performance Charts / Data section for details.
loads and other factors. See Performance Charts / Data section for details.
| STANDARD SIZES | |||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|
| Conveyor Width Reference | 02 | 03 | 04 | 05 | 06 | 08 | 10 | 12 | 18 | 21 | 24 |
| Conveyor Belt Width (W) | 1.75” (44) |
2.75” (70) |
3.75” (95) |
5” (127) |
6” (152) |
8” (203) |
10” (254) |
12” (305) |
18” (457) |
21” (533) |
24” (610) |
| Conveyor Length Reference | 0200 | 0001 increments up to... | 1800 | ||||||||
| Conveyor Length (L) | 2’ (610) | .12” (3) increments up to... | 18’ (5,486) | ||||||||
Note: Lengths 13’ to 18’ available in widths 6” to 24” only.
Gang Drive Conveyors: Non-V-Guided belts up to 24” (610) wide, V-Guided belts up to 18” (457) wide
Gang Drive Conveyors: Non-V-Guided belts up to 24” (610) wide, V-Guided belts up to 18” (457) wide
Notes:
-
Conveyor load capacity depends on conveyor size, incline, motor position, accumulated loads and other factors. See Performance Charts / Data for details.
-
Order gearmotor mounting packages and gearmotors separately - see Mount Packages and Gearmotors. For support stands and accessories - see Support Stands and Accessories.
-
Dimensions are represented in inches, feet, and (millimeters).
-
Due to the wide variety of drive set-ups and applications, point of installation guarding is the responsibility of the end user.
-
Conveyors longer than 12’ (3658mm) will be constructed using a multiple piece frame. Consult factory for locations of these frame joints. It is recommended that each frame joint be supported by a stand or other means.